What I did until many slimes spawn on slime chunk

• What I did
  • Waiting place and not to spawn mods
  • Create Multi layers
  • Sprinkling is the most difficult
  • About timing when slime spawns
  • Once Despawn
  • A sure way
• Build slime farm trap tower
• Conclusion

What I did

First I found a slime chunk using Slime Finder.
This is the basic in the basics.

1. Dig into Y=40 heights in the slime chunk found.
2. From there continue to create a space of height 3 until it hit the ground.
3. Fills a range of 128 squares from the slime chunk with torches.
4. Wait at least 28 blocks and not more than 128 blocks from the slime chunk.

The above is the basis of how to spawn slime.
But I did not spawn a lot of slime with just the above.
So I repeated a lot of trial and error.

Waiting place and not to spawn mods

Once you have created a layer, you have to wait in the range from 28 to 128 blocks from there.
And mods must not to be spawned against X axis, Y axis Z axis within 128 blocks from this waiting place.
You must make the range of 128 blocks brighter with a torch etc.

Create Multi layers

No matter how much you place a torch, slime will hardly appear with just one layer.
If slime does not occur, please create 2 or 3 layers.
Then the probability of occurrence of slime increases.

Sprinkling is the most difficult

Because there are underground caves, valleys and spawn blocks that have not been seen yet.
If slime does not occur, there is a high possibility that these dungeons still exist.

About timing when slime spawns

I tried it a lot of patterns but I did not understand timing.
Sometimes it happens only when we are stopped, or it happens when we are walking around.
Just from the experimental results I think that there was a high possibility that walking would occur.
As walking around, the range of Spawn/Despawn changes gradually, so it may be that slime spawned newly at the timing when other mobs despoed.

Once Despawn

Simply let’s go far away from the slime chunk.
Then the mob around the slime chunk once despawn.
Slime may have occurred after returning to the waiting place again after that.

A sure way

The most reliable way is to create an ultra-huge space in the range of 256 x 256 below Y=40 height.
And if you place torches in that range, only that slime on the slime chunk will occur within that range.
However, since the number of blocks to be mined is about 256 * 256 * 40 = 2621440 in a simple calculation, I think that it is quite difficult.
And when doing this please be sure to check that the waiting place will be in the center of 256 x 256.

Build slime farm trap tower

Actually, I finally created a slime farm.
I made nine layers with a height of 2.5 breaks.
Of course I also squashed from the waiting place with many torches.
Now that a lot of slime has come to be generated, there are things that need attention.

• Do not do branch mining like creating a new slime chunk around the waiting place.

Creating a new space creates a new mob there.

Additionally there was a way that was quite effective to make it spawn.

• Try to keep moving forever with trucks and rails.

The reason for this is also unknown, but it is more efficient to spawn if you continue to move rather than waiting.
The moving size of the truck is about 3 x 3 and it’s okay.
Let’s move forever with powered rails.

Conclusion

The most important thing is perseverance.
Let’s test it many times and grab the pattern where slime occurs.